GIGABYTE, AMD, AM2+, 790X (GA-MA790X-DS4 1.0)

Sem imel to plato, pa mi je po kakih treh mesecih crknila. Drugače pa je kar solidna plata. Edino kar me moti pri njej je to, da je opremljena z južnim mostom SB600, ki pa ni ne vem kako dober. Sem pa na njej mel navitega Phenoma X3 8450 na 2900MHz in je delalo brez problema. Sam bi ti priporočal katero drugo plato, recimo ASUS M3A-H/HDMI za slabih 79€. Kateri procesor pa imaš in če boš kaj navijal.

Koliko ga pa naviješ sedaj?

The major downsides of SB600 according to user consensus are:



a) RAID errors and erratic functioning in RAID 0/1, specifically on Vista 64-bit.

b) AHCI not working properly so SATA drives nearly always are running in IDE UDMA 6 mode.

c) HDD and ODD SATA/IDE combinations on many motherboards may not function correctly or not function at all due to SB600 problems which are not remedied in the BIOS releases although could be.

d) Lower USB and HDD performances in general.

e) A clock generator bug which means it will induce erratic overclocking behaviour every 9/10 attempts and limit the processor overclock somewhat substantially with the known "poor overclockers". The cause is very likely on-die PLL's falling out of the required phase synchronization window parameters.

f) For the same reasons, poor and/or limited HT overclocking.



The latter two are critical problems for overclockers in that, you can fall 200 - 500 MHz short of the actual overclocking silicon frequency limit due to synchronization errors within the allocated time.

Vzeto iz http://forums.amd.com

Torej je Asus M3A-H/HDMI prava zate.

2.7 Ghz na ASUS M2N-E

Za 300MHz navitje je brez veze zapravljati denar za novo matično. Na koncu bi se pa še mogoče izkazalo, da te v resnici omejuje slabši primerek procesorja...
Če si že tako zagret za menjavo, potem vsaj pri kom stestiraj svoj procesor, če je v resnici kriva plata za po tvoje slabo navitje.

Mislim da moraš AI Overclocking nastavit na Manual.