Ne najdem supporta za plato HELP!!!

Rabu bi bios nadgradit na moji plati pa ne najdem enga supporta pa sm cel google že narobe obrnu

Podatki o moji plati kopirani iz SiSoft Sandre:

Mainboard
Manufacturer : Procomp Informatics
MP Support : No
Model : i810-W83627HF
System BIOS : 09/21/2000-i810-W83627HF-6A69MPNAC-00
Chipset : Intel 810 (Whitney)

FLASH Memory Controller
Location : Mainboard
Error Correction Capability : None
Number of Memory Slots : 2
Bank0/1 - A0 : DIMM 64MB/64
Bank2/3 - A1 : DIMM 64MB/64

Chipset 1
Model : Intel Corporation 82810 810 Chipset Memory Controller Hub
Bus(es) : ISA PCI USB i2c/SMBus
Front Side Bus Speed : 1x 67MHz (67MHz data rate)
Maximum FSB Speed / Max Memory Speed : 1x 100MHz / 1x 100MHz
Width : 64-bit
IO Queue Depth : 4 request(s)

Chipset 1 Hub Interface
Type : Hub-Interface
Version : 1.00
Number of Ports : 1
Width : 8-bit
Full Duplex : Yes
Multiplier : 1/1x

Logical/Chipset 1 Memory Banks
Bank 0 : 64MB SDRAM 3-3-3CL
Bank 2 : 64MB SDRAM 3-3-3CL
Shared Memory : 1MB
Width : 64-bit
Refresh Rate : 15.60žs
Power Save Mode : No
Fixed Hole Present : No

Memory Module(s)
Memory Module 1 : 64MB 4x(8Mx16) SDRAM PC133U-333-542 (CL3 up to 133MHz) (CL2 up to 100MHz)
Memory Module 2 : 64MB 8x(8Mx8) SDRAM PC133U-333-542 (CL3 up to 133MHz) (CL2 up to 100MHz)

Environment Monitor 1
Model : Winbond W83627HF ISA
Version : 2.01
Mainboard Specific Support : No


Temperature Sensor(s)
Board Temperature : 37.0°C / 98.6°F
CPU Temperature : 43.0°C / 109.4°F
Power / Aux Temperature : 73.0°C / 163.4°F


Cooling Device(s)
Auto Fan Speed Control : No
CPU Fan Speed : 5273rpm

Voltage Sensor(s)
CPU Voltage : 1.71V
Aux Voltage : 2.54V
+3.3V Voltage : 3.44V
+5V Voltage : 5.00V
+12V Voltage : 12.16V
-12V Voltage : -11.62V
-5V Voltage : -5.05V
Standby Voltage : 4.97V
Battery Voltage : 3.41V

PCI Bus(es) on Hub 1
Version : 2.10
Number of Bridges : 1
PCI Bus 0 : PCI (33MHz)
PCI Bus 1 : PCI (33MHz)
Multiplier : 1/2x

LPC Hub Controller 1
Model : Intel Corporation 82801AA 8xx Chipset LPC Interface Bridge
ACPI Power Management Enabled : Yes
Random Number Generator Enabled : No
Random Number Generator Support : Yes
Delayed Transaction Enabled : Yes

USB Controller 1
Model : Intel Corporation 82801AA 8xx Chipset USB Controllers
Version : 1.10
UHCI Interface : Yes
Channels : 2
Speed : 48MHz
Legacy Emulation Enabled : No

System SMBus Controller 1
Model : Intel 801xx SMBus
Version : 0.02
Slave Device Enabled : No
Speed : 16kHz

Expansion Slot(s)
PCI (1Eh) : PCI 32-bit +5V Full-Length Used (Intel Corporation 82801AA 8xx Chipset Hub to PCI Bridge)
PCI (10h) : PCI 32-bit +5V Full-Length Available
PCI (14h) : PCI 32-bit +5V Full-Length Available
PCI (B4h) : PCI 32-bit +5V Full-Length Available

Port Connector
PRIMARY IDE : None - ATA / None
SECONDARY IDE : None - ATA / None
FDD : 8251 FIFO - Floppy Disk / None
COM1 : Serial Port 16450 - 9 Pin Dual Inline / DB-9 pin male
COM2 : Serial Port 16450 - 9 Pin Dual Inline / DB-9 pin male
LPT1 : Parallel Port ECP/EPP - DB-25 pin female / DB-25 pin female
Keyboard : Keyboard - None / PS/2
PS/2 Mouse - Detected : Mouse - PS/2 / PS/2
USB : USB - None / None

Performance Tips
Notice 224 : SMBIOS/DMI information may be inaccurate.
Warning 2507 : Mainboard has too few memory slots. Upgrading the memory may be difficult or expensive.
Warning 2508 : All memory slots are full. Upgrading the memory may be difficult or expensive.
Warning 2544 : System/Video shared memory greatly reduces performance. Use external video card.
Warning 2518 : Mainboard temperature is too high.
Tip 2 : Double-click tip or press Enter while a tip is selected for more information about the tip.

TNX sm že jest tud po procompovi strani isku (sam jest pa tiste njihove grable je pa neki ) ok dej me pa še zanima kak bi jest tisto slikco v biosu zamenju sm članek prebrau sam mi ni jasno kje najdem tisto številko de vidim a lahka spremenim slikco al ne.
Aja pa mal helpa bom nucu tud z samim flashanjem k prvič delam to .

TNX za any help !

kaj pa če bi mal pogledal pod ISKANJE : flash+bios

poglej mal po starejših temah, nekaj se bo že našlo, ker se mi zdi, da je bilo o vsem tem in pa tudi o tvoji slikci ( ISKANJE: epa+slikca) dosti napisanega

lp