Finished System

Nice work!

Naj nek moderator premakne to v Hlajenje in modifikacije ker se je tam odvijala ta debata..

Neat!

Another photo

Kaj če bi vse slike dal v en post, pa jih tako zmanjšal, da bi bile vidne na 1024 na celem zaslonu, in ne čez.

Bo držalo, tako da še enkrat v angleščini.
Hunter: the next time try to post all the pics in one post, and fit them for 1024*768, not everyone has the better resolution.

Spet Sergio da nek kompliment :D :D :D Eno uprasanje mam zate. Ce bi recmo jst neredu clank kukr je ze dost folka, al pa test necesa, kaj morm narest :8) :8) :8)

Very nice job!>:D Temps (in C)?

What's that hose going to the upper part of the case?

And what are the temperatures? Have you tested how does having the radiator inside the case (as opposed to having it outside) affect them?

I think the hose is some kind of filling system. You have to get the water in somehow:) .

The hose or T fitting is used to add water and to bleed air from the system. I am using two 120mm 86 cfm fans in a push/pull format. Another two 80mm 33 cfm fans are removing air from the case out the back. This setup allows a positive pressure within the case. After checking this setup at different ambient temps I have found that my cpu and case temps are always 10c apart. Currently the case temps are 23c and the cpu temps are 33c. When running Prime95 torture test my cpu temps climb to 36c. I am using distilled water with Redline Water Wetter. 32/1 ratio. I was using 85 percent distilled water and 15 percent anti-freeze. This was my first attempt at water-cooling and I am very happy with the outcome. By having the radiator inside the case my case temps are up maybe 1c higher than when this system was air-cooled.